Woodcraft Insert – Split 3D Printer Model
The file 'Woodcraft Insert – Split 3D Printer Model' is (stl) file type, size is 161.5KB.
The file 'Woodcraft Insert – Split 3D Printer Model' is (stl) file type, size is 161.5KB.
This is a remix of the WoodCraft insert made by Wityender. The main storage component is too big to fit on smaller printers, so I split it in two. Note that the two split parts are dimensionally accurate to the original, so it won't take up more space in the box. However, due to the lack of one leg of the card holder on the right split piece, you will need to glue the two pieces together. I found that super glue (CA glue) worked great for me. Supports are needed for the split insert.
Additionally, I found that getting the player boards and main board out of the box is difficult, so I made a board clip that goes around the 5 boards. This allows me to grab the clip and lift out the boards easily.
Finally, I modified the remaining box spacer and added 3 cups to hold 3D printed blueberries (https://www.thingiverse.com/thing:6072772). If interested, I printed the following quantities:
18 of the 1-Value berries = 18 total blueberry value
15 of the 3-Value berries = 45 total blueberry value
14 of the 5-Value berries = 70 total blueberry value
| BlueberryCup-Size1.stl | 95.2KB | |
| BlueberryCup-Size3.stl | 95.2KB | |
| BlueberryCup-Size5.stl | 95.2KB | |
| BoardLiftClip.stl | 14.5KB | |
| Empty_Space-ExtendedSides.stl | 74.4KB | |
| MainBox-L.stl | 60.9KB | |
| MainBox-R.stl | 103.2KB |
