Wolverine Wraith CO2 Stock Gen1 Drill Guide 3D Printer Model
The file 'Wolverine Wraith CO2 Stock Gen1 Drill Guide 3D Printer Model' is (stl) file type, size is 27.4KB.
The file 'Wolverine Wraith CO2 Stock Gen1 Drill Guide 3D Printer Model' is (stl) file type, size is 27.4KB.
Drilling guide in case you need to open up the hole in your AEG receiver to fit the Wolverine Wraith CO2 stock Gen1. It will also fit for the Gen2, if it uses a thread with 9.5mm outer diameter.
It fits on every standard AEG stocktube mount and is meant to be used with a 10mm drill.
PET-G or ABS recommended. PLA can be used but the drill should be water cooled to prevent melting the PLA. Dry your drillbit properly after using water and oil it to prevent rust. And don't use the guide for more then one operation.
| Bohrhilfe_Wolverine_Wraith_v1.stl | 134.2KB |
