This is specifically for the V3 version. It will not fit into V2, but V3 does not allow for remixes for some reason.
The regular version of this sword requires carbon rods inside it to hold it together. This model allows you to put together the whole sword with just what your printer can make.
The rods are split in half, as filament prints are stronger horizontally than they are vertically. You need to print each half twice to get one full rod.
In total, you will need 5 short rods (10 pieces total) and 1 long rod (2 pieces total). Check the image in the remix to see where each rod fits.
Additionally, it is advised to set the rod's size to 95% during slicing, as various imperfections on the print's surface might make it harder to insert.
| Rod_Long.stl | 3.7KB | |
| Rod_Short.stl | 3.7KB |
