Wolfcraft Work Table Clamp Adapter 3D Printer Model
The file 'Wolfcraft Work Table Clamp Adapter 3D Printer Model' is (stl) file type, size is 84.4KB.
The file 'Wolfcraft Work Table Clamp Adapter 3D Printer Model' is (stl) file type, size is 84.4KB.
Two pieces that turn Wolfcraft one-hand clamps into vertical work table clamps for all work tables with 20mm bore holes. So it is not just limited to the Wolfcraft Master 650 table shown in the pictures, nor to specific table thickness.
Usage: push the lower part (wedge) fully through a table hole, then pull down the hat piece until it's fully inside the table hole, then tighten the one-hand clamp as you usually would.
Assembly: orientation matters! Both pieces do have an arrow that should point into the front facing direction of the clamp! I used a M5x10mm hex screw to fix the lower part (wedge) to the clamp. M5x16mm screws should work as well I guess, but haven't tested.
Compatibility: These adapters should fit all smaller Wolfcraft clamps like the EHZ 65-150, EHZ 65-300 and many more that do have the 14x5mm metal rods. It does not fit with the largest Wolfcraft clamps that have 20x6mm metal rods.
| wolfcraft_table_clamp_hat.stl | 218.1KB | |
| wolfcraft_table_clamp_wedge.stl | 13.4KB |
