A wall mount for my cartridge press from wolfcraft. (MG 600 PRO)
I almost doubt this mount will work for any other cartridge press, but to all the lucky ones out there who have the same one as me, here you go.
The bracket has three bulges on the left and right side of the back to pull cable ties through. Accordingly, the mount was also only attached to a storage shelf with two cable ties in my case
The print is quite simple, but I recommend to take the version where I have designed the support structure myself, so it is easier to remove it later from the print.
As always in my designs, I did my best to avoid the need for supports in printing and kept the print itself simple. Do the environment the favor and produce less waste.
| without_support.stl | 797.8KB | |
| with_support.stl | 809.0KB |
