Useful accessory for RC planes - printed wires duct (11x29mm) for foam fuselage. Suitable for 3-6mm thick depron/foam sheet. Easily fits motor wires with 3.5mm connectors and 20A ESC. Parts printed in PLA as shown on stl preview , layer 0,2mm, no support.
Use tempate to mark a proper place for the duct, cut out the foam, then glue the duct frame (I use epoxy).
My other 3D printed parts for foam RC planes (the list will be updated):
Servo mount for foam fuselage
https://www.thingiverse.com/thing:6644141
Damped tail landing gear for foam RC plane
https://www.thingiverse.com/thing:6644970
Wing servo mount for foam RC plane
https://www.thingiverse.com/thing:6645037
Tool for sanding of KFm-2 airfoil leading edge
https://www.thingiverse.com/thing:6646217
Landing Gear Velcro Mount for Foam RC Plane
https://www.thingiverse.com/thing:6651345
Landing Gear Wheel Stopper
https://www.thingiverse.com/thing:6666224
Servo Push Rod Lock (0.8-1.2mm Wire)
https://www.thingiverse.com/thing:6670936
| cable_duct.stl | 36.0KB | |
| cable_duct_template.stl | 23.5KB |
