WIP Helicone Antenna 3D Printer Model
The file 'WIP Helicone Antenna 3D Printer Model' is (stl) file type, size is 691.9KB.
The file 'WIP Helicone Antenna 3D Printer Model' is (stl) file type, size is 691.9KB.
WIP collapsible Helicone Antenna with brass rods as hinges and a flexible wire mesh as the cone. Also needs a lot of m2 self tapping screws...
Rubber bands go into the slits to make it stay open. Normal ones degraded after a few months. Cheap hairties too. Silicone bands seem to work much better. Some 10cm diameter silicone jar seals have been holding up for 2 months now!
for the mesh do not use:
Most promising material so far:
| dsgc_helix_v5strutted.stl | 712.4KB | |
| handle-oriented.stl | 471.1KB | |
| Hub.stl | 2.7MB | |
| innerRing.stl | 376.7KB | |
| leg-oriented.stl | 515.4KB | |
| meshCover-oriented.stl | 29.8KB |
