WinWing Airbus FCU And Saitek/Logitech Flight Panel Attachment Modules 3D Printer Model
The file 'WinWing Airbus FCU And Saitek/Logitech Flight Panel Attachment Modules 3D Printer Model' is (stl) file type, size is 6.7MB.
The file 'WinWing Airbus FCU And Saitek/Logitech Flight Panel Attachment Modules 3D Printer Model' is (stl) file type, size is 6.7MB.
Modular attachments for Winwing Airbus FSU and Stream Deck on Saitek/Logitech Flight Panels
Models designed with .4mm nozzles and print quality at standard settings. Place the selected 3d model of the slicer of your choosing with the backside placed on the hotbed. The FSU Modules can be fasten directly above the flight panel housing or offset to middle with 2 flight panel mounted sided to side.
Support is needed on the middle section overhang in the slicer program. This design choice was necessary to give easier access to the 2 USB ports on the back of the Winwing FSU.
Screws needed
3D Print to Saitek/Logitech Flight Panel housing
M4x6mm or longer, socket cap screws
3D Print to FSU
Sides: M5x6mm: 4
Back Top: M5x8mm 2-4
Back Lower: M5x20mm 2-4
M4x22mm with washer that came with the Winwing Airbus FSU
The Stream Deck Module only works with the legacy 15 key version
| Stream_Deck_Module_Full_Cover.stl | 800.2KB | |
| Stream_Deck_Module_with_screwdriver_access.stl | 6.3MB | |
| Winwing_FSU_25cm_full.stl | 2.1MB | |
| WinWing_FSU_28cm_full.stl | 2.1MB | |
| Winwing_FSU_Full_with_Sides.stl | 2.0MB | |
| Winwing_FSU_Left_Half.stl | 1.1MB | |
| Winwing_FSU_Left_Half_with_side.stl | 1.1MB | |
| Winwing_FSU_Right_Half.stl | 1.1MB | |
| Winwing_FSU_Right_Half_with_side.stl | 1.1MB |
