Useful accessory for RC planes - 9g servo mount for KFm2 (and other flat bottom) wing - for those who don't like to glue servos. Parts printed in PLA as shown on stl preview , nozzle 0.4mm, layer 0.2mm, no support.
Glue (I use epoxy) the whole servo frame to the wing (no glue on middle perforated part), cut out both (top and bottom) perforated parts, insert and scerw on the servo.
My other 3D printed parts for foam RC planes (the list will be updated):
Servo mount for foam fuselage
https://www.thingiverse.com/thing:6644141
Damped tail landing gear for foam RC plane
https://www.thingiverse.com/thing:6644970
Tool for sanding of KFm-2 airfoil leading edge
https://www.thingiverse.com/thing:6646217
Wires Duct for Foam RC Plane
https://www.thingiverse.com/thing:6650546
Landing Gear Velcro Mount for Foam RC Plane
https://www.thingiverse.com/thing:6651345
Landing Gear Wheel Stopper
https://www.thingiverse.com/thing:6666224
Servo Push Rod Lock (0.8-1.2mm Wire)
https://www.thingiverse.com/thing:6670936
| Servo_KFm2wing_L.stl | 123.2KB | |
| Servo_KFm2wing_R.stl | 123.2KB |
