I wanted/needed a wine glass holder for my camp chair.
After a lot of looking around, mainly at in-store designs.
I found nothing that suited, so i at started look at DIY.
I found hughker's Shower / Bath Wine Glass Holder
https://www.thingiverse.com/thing:2754206/
With a bit of hacking in tickercad, and a hook&loop fastener.
I had a suitable unit.
It is good for a 20mm upright pipe with something for it to rest on.
Printed at .15 (but .2 should work as well)
I think I has a 30% in fill.
Printed upside down, Without brim or supports
Hope this is useful for someone else, or someone will make it better.
| Chair-wine2.stl | 514.2KB | |
| tinker.obj | 325.8KB |
