Windshield Washer Fluid Funnel For VW / Audi / Skoda / Seat 3D Printer Model
The file 'Windshield Washer Fluid Funnel For VW / Audi / Skoda / Seat 3D Printer Model' is (f3d,stl) file type, size is 2.7MB.
The file 'Windshield Washer Fluid Funnel For VW / Audi / Skoda / Seat 3D Printer Model' is (f3d,stl) file type, size is 2.7MB.
Refilling windshield washer fluid can sometimes be a mess, but not anymore!
This funnel is designed to be used when refilling windshield washer fluid with minimum waste of washer fluid.
Handle: This funnel has a handle for easy holding.
Air: This funnel features a little hole, allowing air to flow out of the funnel in case the fluid should be rising.
This funnel is made to fit cars from the Volkswagen Group such as Volkswagen, Audi, Skoda and Seat.
Tested on Seat Ibiza and Seat Arona.
This model can be printed as oriented in the attached .stl file.
If the funnel needs to look perfect, then supports would be recommended, however support is not necessary at all, as I printed it without support.
Brim or good bed adhesion is recommended.
As always, be sure to ask any questions you might have, leave a like and post a make :D
| WindshieldWasherFluidFunnel.f3d | 217.9KB | |
| WindshieldWasherFluidFunnel.stl | 7.6MB |
