Window Shelf For Plant 3D Printer Model
The file 'Window Shelf For Plant 3D Printer Model' is (scad,stl) file type, size is 243.1KB.
The file 'Window Shelf For Plant 3D Printer Model' is (scad,stl) file type, size is 243.1KB.
I was looking for a place to put my Basil plant and I did not want to put up a large shelf and block the window.
This shelf uses two T-nuts to grip onto the slot on the edge of my vinyl window (horizontal slider). If you have a similar window you might have to remove a trim / cover piece from the slot to gain access. The customized T-nuts come from https://www.thingiverse.com/thing:1729060 . Your dimensions for the nuts will likely vary and so you should measure the opening. Mine was 22mm and that is the size of the T-nut here. You can customize the L/R alignment of the screw holes on the shelf by using Open SCAD and the shelf SCAD file here. I found some very short wood screws to assemble it which are simpler than machine screws. Assembly is tricky as I had to support the back of the T-nut with my pinky finger while I drove in the screw. A large window can support multiple shelves which can be slid up or down by loosening the screws. The sliding window will still open to about 90% of its width
| flower_shelf.scad | 771.0B | |
| flower_shelf.stl | 710.6KB | |
| tnut.stl | 5.6KB |
