Wind Waker Master Sword – Full Size 3D Printer Model
The file 'Wind Waker Master Sword – Full Size 3D Printer Model' is (stl) file type, size is 576.9KB.
The file 'Wind Waker Master Sword – Full Size 3D Printer Model' is (stl) file type, size is 576.9KB.
This is a full size Wind Waker master sword based on the design by Budward.
I have scaled the model up to better match realistic proportions. (see scale compared to Master sword by Chaos core tech Master sword above)
I have also cut the sword into printable pieces, however they might be too big for some printers.
To assemble:
1: assemble the full blade using the pins. Since the pin holes are not perfectly centered, If a piece is put on backward, the blade won't line up. Make sure you know exactly how all the pieces should fit before gluing.
2: slide the top handle piece up under the blade. It might need some sanding to fit
3: slot the bottom handle piece onto the bit of the blade sticking out of the top handle piece
4: pop the gems into place
Print settings:
printed at a 0.15mm layer height on Bambu lab Carbon X1
4 perimeters
20% infill
no parts need support except for the top handle. Which needs as much as it can get for the wing parts.
no rafts needed for any parts
| ww_blade_bottom.stl | 242.4KB | |
| ww_blade_middle.stl | 115.0KB | |
| ww_blade_top.stl | 47.5KB | |
| ww_gem_.stl | 22.0KB | |
| ww_handle_bottom.stl | 592.1KB | |
| ww_handle_top.stl | 503.5KB | |
| ww_pin.stl | 684.0B |
