Winchester Revolver Prop 3D Printer Model
The file 'Winchester Revolver Prop 3D Printer Model' is (stl) file type, size is 2.7MB.
The file 'Winchester Revolver Prop 3D Printer Model' is (stl) file type, size is 2.7MB.
This is my revolver winchester! when you pull the lever, the revolver rotates! It is completely 3d printed with no extra pieces you need to buy!
2.23.2020: I added picture by picture assembly of the complicated bits in the build. You should be able to use them as an assembly guide for how this goes together. keep in mind, the front ratchet and the back ratchet that hold the cylinder in place are mirrored, so the pieces are not interchangeable. In the photos I only show 2 of the 4 springs inserted into the ratchets, however you will want to put all 4 springs in place.
Before you start to glue things in their place, I would recommend doing a test fit on all the parts to make sure they fit nicely.
If you have any further questions don't hesitate to ask! I check my thingiverse every few days and will try my best to address you.
Iv'e been holding off on posting this model for a while because it isn't finished, but I don't know when I will get back to it so I figured I would post it. The only part to be completed still is the trigger. Everything else works, gears, ratchets and all. I really wanted to make a model that was 100 percent 3d printed without any other pieces, so anyone can print it and build it. I ran into an issue however on trigger design, as I struggled to come up with a mechanism that would click the trigger when you pulled it. Especially with the limited space available. I'll finish this when I think of a good trigger design that consists of only 3d printed parts! Until then, have fun printing this!
Note: print the internals and gears with 60% or more infill, and really high detail for best performance, everything else can be lower detail.
| barrel_center.stl | 536.3KB | |
| barrel_end.stl | 598.1KB | |
| faceplate.stl | 143.0KB | |
| front_rachet_center.stl | 204.4KB | |
| front_rachet_housing.stl | 125.0KB | |
| front_rachet_spring_x4.stl | 108.3KB | |
| gear_housing_rachet_spring_x4.stl | 108.3KB | |
| gear_main_shaft.stl | 375.1KB | |
| gear_on_housing.stl | 982.1KB | |
| gear_on_shaft.stl | 1.2MB | |
| Gear_pin_cap_1.stl | 112.4KB | |
| Gear_pin_cap_2.stl | 125.6KB | |
| lever.stl | 653.2KB | |
| main_housing.stl | 315.8KB | |
| main_housing_rachet_center.stl | 179.0KB | |
| rachet_main_housing.stl | 1.1MB | |
| revolver_round.stl | 1.1MB | |
| stock.stl | 1.1MB | |
| stock_1.stl | 537.4KB | |
| straight_gear.stl | 801.1KB |
