Parts needed to build a model:
5x wheels
2x axles
1x body
1x windshield
1x rear wheel mount (little stub)
1x steering wheel
I printed everything at once in around 12 or 13 hours, but the steering wheel and rear wheel mount did not turn out well becuase of how thin they are. I printed those again by themselves and they turned out much better. Also, the arms that mount the windshield did not really print. I did not have time to remomdel them becuase I was giving this to my grandpa so I superglued it on. You can try to remodel it or just print it out and superglue it on.
-Good luck and thank you to azzraeli!
| Willys_Jeep_13.stl | 1.3MB | |
| Willys_Jeep_14.stl | 64.1KB | |
| Willys_Jeep_3.stl | 128.5KB | |
| Willys_Jeep_4.stl | 8.5KB | |
| Willys_Jeep_5.stl | 3.8KB | |
| Willys_Jeep_7.stl | 35.7KB | |
| Willys_Jeep_9.stl | 598.6KB |
