Wifi Pineapple Nano Protector 3D Printer Model
The file 'Wifi Pineapple Nano Protector 3D Printer Model' is (stl) file type, size is 77.6KB.
The file 'Wifi Pineapple Nano Protector 3D Printer Model' is (stl) file type, size is 77.6KB.
Love my pineapple, but when using my large antenna's I've needed to support them somehow when putting it in my backpack so I figured a nice simple case would be best.
All port's are accessible except for the SD card slot which has room, but is enclosed inside the case.
Designed around the 10dbi antenna's like here: http://a.co/gctHsL7
They were the largest one's I had, figured if it fit them, the case would fit any of my other's fine.
--- EDIT ---
Updated the top section as the original one uploaded has a small hanging mistake that should have been deleted. Fixed the source so both the fixed file here and on tinkercad are good.
I printed it with the mistake in place and just trimmed it off afterwards, it didn't hurt anything, just don't want to leave something half finished :)
| wifi_pineapple_nano_protector-bottom-DBS.stl | 327.2KB | |
| wifi_pineapple_nano_protector-top-DBS.stl | 354.6KB | |
| wifi_pineapple_nano_protector-top-fixed-DBS.stl | 345.7KB |
