The two halves of the case are attached to each other with M3x7 screws or similar through holes on the board, thus securely securing it. The lens for the indicator must be glued.
Print everything without support.
AlfaCase_bottomtext - the bottom cover with the inscription ALFA
AlfaCase_top_MiniUSB - top cover with a hole for the MiniUSB connector (was by default)
| AlfaCase_bottom.stl | 216.9KB | |
| AlfaCase_bottomtext.stl | 211.4KB | |
| AlfaCase_led.stl | 47.7KB | |
| AlfaCase_top_MicroUSB.stl | 753.6KB | |
| AlfaCase_top_MiniUSB.stl | 754.0KB |
