This is a larger set of light bars for use with a large format printer such as a TAZ. You will need a 300mm x 300mm bed to print the strips. There is a recess on either side to allow for solder points and heat shrink as needed, with the cap fitting over the wires. I reccommend also using a layer of transparent Scotch 3m Gift wrap tape over the LED's as well (http://solutions.3m.com/wps/portal/3M/en_EU/ScotchGift/Wrapping/Products/GiftWrapTape/)
| endcap_Brackets_Taz_R_L_2_1_a.stl | 135.0KB | |
| endcap_taz_2_0_a_R_L.stl | 86.6KB | |
| Taz_center_light_bracket_1_0_a.stl | 48.8KB | |
| Taz_Lightstrip_2_1_a.stl | 109.0KB |
