The container is approximately 175mm x 125mm. The height is whatever you want it to be. The sides are 10mm in height and the "Basket Sides" and "Basket Sides 2" can be scaled vertically. One is shown in the last picture.
Assembly is made by the use of 3mm filament rods. Holes in the bottom and tops are very tight so a 3mm or 3.2mm drill bit will probably be needed to widen the holes for assembly. You may want to keep the holes as small as possible so that things do not fall apart during the assembly process.
The "Divider" can also be scaled vertically and cannot be used with the sides labeled "Wicker" or "Wicker 2".
Modified "Basket Lid (Hinged)" because the hinge was too thin. Replaced with "Basket Lid (Hinged) V1A".
| Basket_Bottom.STL | 202.8KB | |
| Basket_Lid.STL | 94.2KB | |
| Basket_Lid_Hinged.STL | 39.3KB | |
| Basket_Lid_Hinged_V1A.STL | 44.8KB | |
| Basket_Sides.STL | 150.9KB | |
| Basket_Sides_2.STL | 129.8KB | |
| Basket_Sides_2_Twisted_.STL | 160.0KB | |
| Basket_Sides_Twisted.STL | 269.4KB | |
| Basket_Top.STL | 242.9KB | |
| Basket_Top_Hinged.STL | 269.2KB | |
| Divider.STL | 2.2KB | |
| Wicker.STL | 36.8KB | |
| Wicker_2.STL | 38.8KB |
