This is a power pod and tail section for my White Diamond RC aircraft as seen on my YouTube channel. I recently started racing my original design with a micro FPV camera, and I wanted to make it easier to swap components without glue or tape.
Assembly is easy with no glue necessary. The bottom of the pod clips over the prop slot, and the front is held on with hook and loop tape passed through the wing and the battery bay. I'm using a 800mah Tattu battery, which fits perfectly in the bay when slid all the way forward. The motor mounting holes are spaced for a 2204 or 2206 motor. Make sure your ESC is far enough back to be cooled by the intakes. Servos can be screwed in, and both halves of the pod clip together in the middle.
Click here to download the free White Diamond plans
Click here for the build video
If you print this model, please consider tipping me a buck or two. It would be a huge blessing since I am currently only working part time in youth ministry.
Thank you!
JG
| Battery_hatch_v4_-_White_Diamond.stl | 107.3KB | |
| Body_front_v4_-_White_Diamond.stl | 546.1KB | |
| Body_rear_v4_-_White_Diamond.stl | 1.5MB | |
| PRUSA_COMPATIBLE_Diamond_Power_Pod_v4_-_Battery_hatch_0.2mm_PLA_1h5m.gcode | 475.3KB | |
| PRUSA_COMPATIBLE_Diamond_Power_Pod_v4_-_Body_front_0.2mm_PLA_4h3m.gcode | 1.1MB | |
| PRUSA_COMPATIBLE_Diamond_Power_Pod_v4_-_Body_rear_2204_0.2mm_PLA_5h12m.gcode | 4.7MB | |
| PRUSA_COMPATIBLE_Diamond_Power_Pod_v4_-_Tail_with_supports_0.2mm_PLA.gcode | 2.8MB | |
| Tail_v1_-_White_Diamond.stl | 123.6KB |
