The wheel chock is intended to show off models in a display or retain them in a diorama. I used these to display my 1:18 and 1:24 model vehicles. At a larger scale, the wheel chock could be used for “real world” wheels, castors and rollers.
Print using filament or resin.Scale as required. For filament prints, use at least 20% infill. Supports are not required.
Clean up and glue the sides onto the ramp.
| Ramp_-_Assembly.stl | 2.8KB | |
| Ramp_-_Holes.stl | 29.8KB | |
| Ramp_-_Plain.stl | 1.3KB | |
| Ramp_x_2_+_Side_x_4_-_Loose_Fit.stl | 175.9KB | |
| Side_-_Loose_Fit.stl | 29.2KB | |
| Side_-_Sliding_Fit.stl | 29.2KB | |
| Side_-_Tight_Fit.stl | 29.2KB |
