Wemos D1 Case With Magnet Holes 3D Printer Model
The file 'Wemos D1 Case With Magnet Holes 3D Printer Model' is (STL,stl) file type, size is 145.3KB.
The file 'Wemos D1 Case With Magnet Holes 3D Printer Model' is (STL,stl) file type, size is 145.3KB.
Needed a case that would stick to the side of my freezer with magnets. Used some 6mm magnets from amazon. 6mm round magnets. Forget the actual listing because it was 10ish years ago.
There are a few different variations of the lid.
For the actual temp sensor I used tasmota firmware, ds18b20, and a wemos D1 mini. It connects to a hubitat, but you could use whatever firmware and connect to whatever service
| d1_case_lid_.STL | 63.8KB | |
| d1_case_lid_sensor_hole.stl | 58.9KB | |
| d1_case_lid_vented.stl | 104.6KB | |
| d1_case_with_magnet_holes.stl | 159.7KB | |
| lid_with_led_hole.stl | 58.9KB |
