Weeping Willow Tree - Try 2
My wife thought my first attempt at a weeping willow tree was too "square" (https://www.thingiverse.com/thing:6540650), so I rounded this version a litte.
Printed using PLA.
Used a layer height of 0.2 mm. However, layer heights of 0.1 mm or 0.3 mm will work since the tree parts are 1.2 mm thick.
Print the following:
One tree_trunk_willow_240318g.stl
One willow_tree_240321k_LARGE_UP.stl
One willow_tree_240321k_LARGE_DOWN.stl
Two willow_tree_240321k_SMALL_UP.stl
Two willow_tree_240321k_SMALL_DOWN.stl
See assembly instructions in images assembly_01.png through assembly_04.png
Additional files:
tree_trunk_willow_240318g.3dxml is a Catia 3Dexperience (maker version) file for the tree trunk geometry
willow_tree_240321k.skp is a Sketchup 2017 file of the branch geometry
| tree_trunk_willow_240318g.3dxml | 121.0KB | |
| tree_trunk_willow_240318g.stl | 47.1KB | |
| willow_tree_240321k.skp | 10.1MB | |
| willow_tree_240321k_LARGE_DOWN.stl | 1.1MB | |
| willow_tree_240321k_LARGE_UP.stl | 1.1MB | |
| willow_tree_240321k_SMALL_DOWN.stl | 883.1KB | |
| willow_tree_240321k_SMALL_UP.stl | 883.5KB |
