This is my attempt at a weeping willow tree.
My wife thought this version looked "too square" so I slightly rounded a second attempt. You may wish to go to this version; https://www.thingiverse.com/thing:6546726
I printed mine using PLA.
I used a layer height of 0.2 mm. However, layer heights of 0.1 mm or 0.3 mm will work since the tree parts are 1.2 mm thick.
Print the following:
One tree_trunk_willow_240318g.stl
One willow_tree_240317e_LARGE_UP.stl (size 175mm X 122mm X 1.2 mm)
One willow_tree_240317e_LARGE_DOWN.stl (size 175mm X 122mm X 1.2 mm)
Two willow_tree_240317e_SMALL_UP.stl (size 175mm X 113mm X 1.2 mm)
Two willow_tree_240317e_SMALL_DOWN.stl (size 175mm X 113mm X 1.2 mm)
See assembly images assembly_01_R2.png through assembly_04_R2.png
| tree_trunk_willow_240318g.stl | 47.1KB | |
| willow_tree_240317e_LARGE_DOWN.stl | 1.1MB | |
| willow_tree_240317e_LARGE_UP.stl | 1.1MB | |
| willow_tree_240317e_SMALL_DOWN.stl | 1.0MB | |
| willow_tree_240317e_SMALL_UP.stl | 1.0MB |
