I wanted a cheap webcam for OctoPrint and the Trust Trino HD webcam was only £8.99 on Amazon, so this design is to mount the webcam on the Ender 3 Pro
To use this webcam holder remove the 2 screws from the supplied mount and use the same screws to fasten the camera to this webcam holder.
The webcam can be adjusted up and down and is held in place by lightly tightening the M8 plastic screw.
I attached the webcam stand to the Ender 3 Pro with 2 M4 screws and T nuts in the slotted base extrusion.
I actually used the fixing screws and T nuts that were removed from the Z stop micro switch when I fitted a CR touch probe.
| M8_screw.stl | 589.1KB | |
| WebCam_bracket.stl | 81.3KB | |
| WebCam_stand.stl | 93.6KB |
