water pump
easy to print, almost no support needed, i used m8 for the shaft and the drill mounting.
the drill i used was 550 watts and 1000 rpm at max
i think the pressure was around 1 to 2 bar.
i used foam tape as a seal for pump cover, but maybe to glue it together is better, because a litle bit of pressure was lost between the cover and the pump house,
you have to hold about 2mm space inbetween the top and the bottom of the impeller
the next one i want to make is a pump for a cordless drill,
so subscribe to my channel if you like that
i can make a version for a stationary motor if enough people are interested in it.
| beugel_boorklem.stl | 50.9KB | |
| boorklem.stl | 96.3KB | |
| deksel.stl | 113.4KB | |
| pomphuis.stl | 424.3KB | |
| vuilkorf.stl | 94.3KB | |
| waaier.stl | 73.8KB |
