Wasp Costume Back Piece Split 3D Printer Model
The file 'Wasp Costume Back Piece Split 3D Printer Model' is (dxf,stl) file type, size is 2.5MB.
The file 'Wasp Costume Back Piece Split 3D Printer Model' is (dxf,stl) file type, size is 2.5MB.
A few years ago I modified the Wasp back armor to split it into two pieces so I could attach wings. I did this in a hurry and with what was probably not the ideal software so it is not perfect, but it works.
I adjusted the back piece to fit my back which I think involved making it taller and narrower. If it helps with sizing I measured the final result and the main piece is around 38cm in height (w/o shoulder pieces) and about 28cm at the widest point.
I also adjusted the size and curve of the pieces that go over the shoulders. Since they were printed separate and I was in a hurry they were just attached to the main piece with tape and a strip of aluminum. I didn't need the shoulders to be functional supports as I attached the main back piece to my actual costume with velcro. The wings were cut/engraved out of acrylic with a local maker-space's laser cutter.
Note: I included the main back piece split in two and whole but I only used the split version. This is from several years ago and I have many files with minor differences so these files may not be exactly the ones I printed, but they were the most recent files I have and looked correct.
| LargeWingSetDesign1.dxf | 107.5KB | |
| LeftShoulder_adjusted.stl | 504.4KB | |
| RightShoulder_adjusted.stl | 504.0KB | |
| SmallWingSetDesign1.dxf | 108.6KB | |
| WaspBack.stl | 1.7MB | |
| WaspBackBotttom_New.stl | 1.2MB | |
| WaspBackTop_New.stl | 661.8KB | |
| WaspUpperBack_New.stl | 1.1MB |
