Wanhao Duplicator I3 Plus Side Filament Guide 3D Printer Model
The file 'Wanhao Duplicator I3 Plus Side Filament Guide 3D Printer Model' is (stl) file type, size is 63.7KB.
The file 'Wanhao Duplicator I3 Plus Side Filament Guide 3D Printer Model' is (stl) file type, size is 63.7KB.
Intended to be used along with a PTFE tube, filament guide can be rotated to suit your arrangement. Rotating portion is not designed to spin freely, it holds in place once the part is attached. You could probably sand it or downscale it slightly if you'd like it to fit loose.
I used 4 m3 x 16mm screws to secure it to the printer, be careful when choosing hardware to ensure the screws do not stick far enough back they can interfere with Z/X movement.
Part is designed in Inches, based off the i3 Plus, I am not certain if it will fit others. Screw spacing is a 1 3/16" square.
...Model is in Inches! Depending on your slicer you may have to manually scale to CM, or say Yes when it asks if you want to auto-scale!...
| FilamentGuidePivotR1.stl | 123.3KB | |
| FilamentGuideSideMountR1.stl | 100.9KB |
