Made this thing to add some tea lights to my shower (who says 3D printing can't be sexy?). The open bottom is for easy removal of the tea candle (standard 39mm tea candle) and for the drainage of water. Included is a corner piece with an additional drainage hole. I used a temperature gauge to make sure that the PLA I used wasn't going to melt and after 30 minutes of burn time, the wall above the flame was still only around 30C. The heat seems to go straight up from these little candles so melting shouldn't be an issue (foreshadowing).
Mounted on the shower wall with some waterproof double sided tape.
V3 Update** Made the collar slightly wider. When these tea candles burn all the way down, the heat may shrink the top of the collar slightly.Try not to let them burn all the way down but the extra wiggle room should be enough to compensate for any heat shrinking
| Candle_mount_v3.stl | 58.3KB | |
| Candle_mount_v3_CORNER.stl | 60.1KB |
