Wall Mount For Lego Ferrari Daytona SP3 3D Printer Model
The file 'Wall Mount For Lego Ferrari Daytona SP3 3D Printer Model' is (STL) file type, size is 5.5KB.
The file 'Wall Mount For Lego Ferrari Daytona SP3 3D Printer Model' is (STL) file type, size is 5.5KB.
This is a wall mount for the recently released Lego Ferrari Daytona SP3 Model. It hangs the car from the holes in the floor located directly under and in front of the seats. The car sits on the two orange pins found at the front of these holes. The point of the mounting bracket is centered side to side on the car and sits exactly 7 inches from the front of the nose. Please be careful hanging your car and either screw directly into a stud or use appropriate wall anchors.
Hope everyone is enjoying this fantastic set as much as I have!
Side Note: Due to the way the doors work, when hanging vertically the doors sit open a small amount. You can fix this by cutting down a piece of the flexible piping like used in the set and bridging it from the door to the side skirt.
| Lego_Ferrari_Mount.STL | 25.3KB |
