Walksnail V2 VTX “Tray” For Dolphin 3D Printer Model
The file 'Walksnail V2 VTX “Tray” For Dolphin 3D Printer Model' is (stl) file type, size is 44.9KB.
The file 'Walksnail V2 VTX “Tray” For Dolphin 3D Printer Model' is (stl) file type, size is 44.9KB.
This is a pretty simple "tray" for mounting a Walksnail V2 VTX onto the nose of the Atomrc Dolphin. It fits between the front nose section and the front canopy, after cutting out a section of foam there to make room for it. Carefully cut away the foam a little at a time until finally trimming for a good final fit. You can take away more foam, but can't put it back. ;) The VTX is mounted to the tray using M2 screws before the tray is glued into the fuselage. To remove it later, either cut the tray out, or poke a drive up through the bottom of the fuselage to get to the screws. There's room for the cables to run down below and into the fuselage. There's a hole in the front for mounting an antenna with a 4mm post, and a place the run the coax cable through the tray. I have my camera mounted to a pan servo in front of the tray as shown.
Also included is a small block that fits into the camera cutout in the front of the nose, that holds the pitot tube for my airspeed sensor.
See it all in action here - https://www.youtube.com/watch?v=vKobNtb3jjk
| Dolphin_Pitot_Tube_Holder.stl | 43.0KB | |
| Dolphin_Walksnail_V2.stl | 158.0KB |
