Wanted a goggle strap mount option, so i modified the body of the existing design to include two rails that slot and sit into the female section i created, the strap is fed through the obvious slot and the module case slots in and sits nicely. Few tips for post printing:

• This module case is very snug and took some sanding down to squeeze in, in the end i wrapped a piece of sandpaper to a small drill bit and used this to take off some material. i think the original design could do with maybe being 0.25-0.5mm longer.

• The hole that provides access to the analogue cable connection doesn't completely allow for the analogue cable that came with the DJI adapter to completely secure, however, i used the cable that came with the goggles X as it has a slimmer profile and I had no issues

• The plastic ring around the SMA connector needs to be removed for the fit and there's a small black rubber cube that provides support in the module, this has been incorporated into the print, at first i was wondering what the obstruction was, then i realised and removed it and it went in perfectly.

• i designed this but didnt do the printing i will update the printer settings when i grab then from a friend.