just used the Moonlight negative to cut a fit and voila
printed in tpu, 15% infill, version 1 pictured
i did use the shortest camera cable to 9mm to make it simpler but I suppose you could stuff any cable so long as you don't pinch anything
the antennae mount optional, you could just use dipole whips out the top with no rear mount
it is a very tight fit, use thin screws, nip out supports as needed, long thin screws
would add 5v powered 25mm fan if on idle/ground device
| Moonlight_GoPro_cage.stl | 408.6KB | |
| Moonlight_GoPro_rear_antennae.STL | 653.2KB |
