The original elephant was printed at 75% reduced size with 10% supports density (to cut down on material removal) using transparent t-glase (Taulman). The base was printed using black PLA and will hold a standard 4xAA battery holder. I used a self-locking mini push button switch (7x7x12mm), 4x 3mm blue LEDs, and 4x150ohm current limiting resistors. Unfortunately the blue LEDs do not photograph well making the colour look a bit more on the purple side in the picture.
| Battery_Compartment_Lid.stl | 9.5KB | |
| Button.stl | 1.4KB | |
| LEDholder.stl | 21.0KB | |
| Stand.stl | 75.0KB | |
| tealight_elephant.stl | 24.3MB |
