3 STL files allowing to enclose and attach a vzbot330 in a ikea bror system shelf
I am still working on enclosure itself. bror 3d model available on internet do not have accurate dimensions so far, so i have to make precise measurement on my own.
Back plate enclosure is particulary difficult because the back of the printer gets partially outside of the shelf.
I use a 65x55 cm bror shelf, attached in a L configuration to a 65x30 cm shelf.
this way the 65x55 is set 10cm away from the wall, which is enough room for the vzbot electronic and cooling system.
| vzbot_bror_ikea_hack_v72_-_door_hinge.stl | 145.6KB | |
| vzbot_bror_ikea_hack_v72_-_door_hinge_support.stl | 136.4KB | |
| vzbot_bror_ikea_hack_v72_-_printer_attach.stl | 62.0KB |
