update: added ball point version
this thing is not going to fit right after you print it, you need to put both bayonet and holster on heated bed then put towel on top and set temperature to 110 degrees wait few minutes so it will be heated up properly after that just push bayonet into holster and leave it inside until it will cools
for print settings i suggest increasing flow rate little bit to compensate for thin walls
| belt_loop_left.3mf | 434.7KB | |
| belt_loop_left_ball_point.3mf | 506.6KB | |
| belt_loop_right.3mf | 438.2KB | |
| belt_loop_right_ball_point.3mf | 508.5KB | |
| ignore_this.stl | 684.0B |
