Remix of Voxelab Aquila Filament Guide by samurai1 , since the previous design was good but the STL was broken in places that only became obvious when slicing.
Ended up with a complete remake in Tinkercad but with such a similar design that it's only fair to still call it a remix - and I've brought through the spacer and runner with no change.
Requires a 608 bearing, and an M3 screw and nut (about 25mm).
Print one copy of the bearing ring, and two of the spacer.
I've made three versions of this design, depending on whether you are expecting to have the spool above, behind, or in front of the printer, the difference being which orientation the bearing runner is at, since you want the filament to go around the runner.
The guide just slides onto the top section of 2020 of the frame, and is a snug fit. You'll fit it upside down compared to the model, as the flange that sticks up in the stl will point downward to give a little more strength against the vertical on the printer.
| Bearing_Ring.stl | 358.7KB | |
| Filament_Guide_above.stl | 124.7KB | |
| Filament_Guide_behind.stl | 103.8KB | |
| Filament_Guide_front.stl | 104.0KB | |
| Spacer.stl | 37.6KB |
