Volvo Rear Armrest Drink Holder Insert With Flexible Tabs 3D Printer Model
The file 'Volvo Rear Armrest Drink Holder Insert With Flexible Tabs 3D Printer Model' is (scad,stl) file type, size is 53.7KB.
The file 'Volvo Rear Armrest Drink Holder Insert With Flexible Tabs 3D Printer Model' is (scad,stl) file type, size is 53.7KB.
The rubber tabs typically rot & break off from the inside of Volvo drink holders, resulting in a loose fit for smaller-diameter drink bottles. Replacing the drink holder tabs on the rear-set armrest normally entails replacing the entire arm rest at a cost exceeding $300 USD before labor (see Volvo 2008-2017 armrest assembly 39828738, 39828738, 39856311, 39862202, or 39807677).
Alternatively, I designed these inserts that simply squeeze in and replace the original broken tabs. (If any part of the old tabs remain, trim them off with an Exacto knife before installing). I glued the replacement insert in place with clear silicone caulk. If you choose not to glue them, the insert can be removed easily for larger-diameter drink containers.
Volvo vehicles with a rear armrest drink holder that this may fit include Volvo V60 2015, V70 2008-2010, XC60 2010-2017, XC70 2008-2014, and perhaps others.
Photo shows my insert (red) installed on one rear-seat drink holder, and the adjacent one with tabs broken off and no insert.
Print with flexible filament such as TPU!
| volvo-rear-cupholder-insert.scad | 5.2KB | |
| volvo-rear-cupholder-insert.stl | 178.3KB |
