Volvo B230F Heavy Duty Intake Elbow (N/A Red Block), 200, 700, 900 Series 3D Printer Model
The file 'Volvo B230F Heavy Duty Intake Elbow (N/A Red Block), 200, 700, 900 Series 3D Printer Model' is (stl) file type, size is 4.3MB.
The file 'Volvo B230F Heavy Duty Intake Elbow (N/A Red Block), 200, 700, 900 Series 3D Printer Model' is (stl) file type, size is 4.3MB.
Beefed up, thickened and fortified intake elbow with flame trap and idle air control fittings for N/A LH Jetronic Volvo B230f engines. Comes in two variants: factory offset version based off the ones from Volvo 700 and 900 series (may not fit Volvo 200 series and may interfere with brake booster lines on certain intake setups), and extra offset version (altered based on Volvo 200 series to give clearance for brake booster and shock tower, may fit other models as long as intake hose is clear).
Does not fit K-jet model
Does not fit turbo model
Cannot verify if it fits B200f engine
Spec:
2.5 inch outlet (to throttle body)
3.0 inch inlet (to intake hose)
All versions requires a 2.5 inch silicone coupling to connect to throttle body, and depending on your current intake setup, an extra 3.0 inch silicone coupling may be needed to connect intake elbow to intake hose.
(Please note: this part cannot be used for commercial purposes due to CAD software licensing agreement. I do not intend on profiting from this design and it's solely created for myself and the RWD Volvo community as a DIY repair component. Print and use this design at your own risk.)
| B230ExtElbow.stl | 5.1MB | |
| B230RegElbow.stl | 5.0MB |
