This is a large old fashioned barn pulley.

It's for decorative purposes such as retro pendant lights or washing lines that need a vintage looking pulley. The pulley takes large rope or cable up to 25mm / 1 inch in diameter.

The overall size is 215mm high, 200mm wide, with a pulley size of 160mm diameter (about 6-1/4" round). Parts will comfortably print on a 200 x 200mm bed - just rotate the side pieces a little so they print on the diagonal.

As well as the printed parts, you'll need some nuts, bolts and washers:

• 2 x 5mm x 50mm pan head bolts for the side spacers
• 1 x 8mm x 50mm pan head bolt for the top hangar
  plus washers and nyloc nuts.

If you choose to print the center pulley in two halves as I did, it can be glued and held together with 5 x 3mm x 18mm screws.

Its the first new thing I've posted for a couple of years so do hope you enjoy! Solidworks files are included - go nuts.