This is a Viking dragon bracelet.

Credit:

It is a remix of my remix of ekul3e3's "Swirly Bracelet" and of my dragon heads.

Files:

there are two different versions:

Originial Version:

• Viking Bracelet: the bracelet by itself.• Viking Bracelet with Experimental Supports: the bracelet with tree supports I added via Meshmixer.

A Slimmer Version:

This is sized the same as the other bracelet. What's different: the swirly part of the bracelet is thinner. The dragon heads are smaller. The very back horns are removed. The front whisker/ horn things are thicker in comparison to the heads.• Viking Bracelet Slim Version: the slim bracelet by itself.• Viking Bracelet Slim Version with Experimental Supports: the slim bracelet with tree supports I added via Meshmixer.

How to put it on:

You can bend the bracelet a little, but it's best you do not bend it as you will fatigue the plastic and it will eventually snap. Check out this video by Professor Rex on how to properly put one on: https://www.youtube.com/watch?v=Kq0SRmpiV4k

Featured images of the one I printed:

I printed both the original and slim versions using wood filament and the experimental supports. Both were stained with wood stainer.

Wrist Size:

This was designed for a wrist 2.75 inches in diameter by 2 inches in diameter. You may need to scale it accordingly.

Adjusting the distance between the heads:

You can use a hairdryer/ heat gun to warm the bracelet and bend the heads closer/ farther apart to your liking.

Infill:

I would suggest a high level of infill for this bracelet. It's worth the extra plastic and time to give it more strength and resistance.