This is my second 3d print project.
Scale: 1/35
Lenght: 730mm
Width: 174mm
The different hull pieces can be aligned with small pieces of 6mm rods or pipes.
The stern tube can have a diameter of 6 or 8mm.
You only need to print the right hull section for the chosen dieamter.
The propeller is desinged for a M4x10x5 threaded brass insert.
It is possible to build the ship with a normal rudder, or a ducted propeller.
You may need a M3 threated insert for the ducted propeller version.
I had problems joining the pieces together, because the printed parts where warped too much. Printing larger thin walls in PETG without an enclosure, seems to be difficult.
I have printed a mold in 1/87, to laminate a hull.
Here is a link to the mold in Fusion 360: https://a360.co/2JWv5SM
You can ask me, if you want to have the stl files for a mold in a specific scale.
| bridge.stl | 48.4KB | |
| cargo_cover.stl | 78.2KB | |
| cowl_vent_8mm_tube.stl | 4.8MB | |
| hull_pt.1.stl | 2.1MB | |
| hull_pt.2.stl | 400.7KB | |
| hull_pt.3.stl | 2.8MB | |
| hull_pt.4.stl | 555.2KB | |
| hull_pt.5.stl | 349.0KB | |
| hull_pt.6.stl | 1.5MB | |
| hull_pt.7.stl | 1.1MB | |
| hull_pt.7_8mm_sterntube.stl | 2.6MB | |
| keel_duct_pt.1.stl | 45.0KB | |
| keel_duct_pt.2.stl | 30.9KB | |
| keel_rudder_pt.2.stl | 36.6KB | |
| keel__rudder_pt.1.stl | 33.4KB | |
| motor_mount.stl | 204.6KB | |
| propeller.stl | 2.0MB | |
| propeller_duct.stl | 1.0MB | |
| roof.stl | 13.6KB | |
| smokestack.stl | 136.9KB | |
| stern_coaming.stl | 12.2KB | |
| stern_cover.stl | 58.1KB | |
| superstructure.stl | 4.6KB |
