Victor Compatible Mouse Trap Hood With Hold Down And Back Hold Down 3D Printer Model
The file 'Victor Compatible Mouse Trap Hood With Hold Down And Back Hold Down 3D Printer Model' is (stl) file type, size is 30.6KB.
The file 'Victor Compatible Mouse Trap Hood With Hold Down And Back Hold Down 3D Printer Model' is (stl) file type, size is 30.6KB.
This is a hoodie for the Victor Mouse Trap. I added two hold downs for the mouse hoodie and a hold down for the back of the mouse trap. This should allow it to be screwed down with four #4* screws. You need to take a couple of needle nose and bend down the metal bait holder.
I added a bait adapter. You will need to bend up the curled metal and make it tightly fit by rolling it in 90 degrees. Remove it and install the mouse hoodie and then the bait adapter again. You can optionally make it held on firmly by bending the metal down.
If your printer has different tolerances you can try to increase the print percentage to make it fit.
See video: https://www.youtube.com/watch?v=sZ3sf0xawdk
Check out the: Wyze Cam v3 Tower Mount - https://www.thingiverse.com/thing:6734226, Customizable Rodent Vacuum - https://www.thingiverse.com/thing:6774185 and Victor Compatible Rat Trap Hood with Hold Down, Bait Adapter and Back Hold Down - https://www.thingiverse.com/thing:6611506.
| Mouse_Bait_Adapter_v1.stl | 41.8KB | |
| Mouse_Trap_Back_Hold_Down_v1.stl | 41.6KB | |
| Mouse_Trap_Hood_v1.stl | 46.5KB |
