I wanted a better way to mount my OSVR camera, so this is what I devised. Since it was designed for a light camera, it's a little floppy. But the thickness can be adjusted in the Customizer, so it could probably manage heavier cameras too.
Hardware you'll need:
2 - M4 x 16mm screws for the monitor (depending on your setup)
2 - 1/4-20 hex-head bolts (I didn't measure but I think about 1")
2 - 1/4-20 hex nuts
1 - 4-40 x 3/4" screw
1 - 4-40 hex nut
| AllParts_r02.stl | 997.4KB | |
| BallMount_r02.stl | 280.4KB | |
| SocketSlider_r02.stl | 140.9KB | |
| VesaMount_r02.scad | 6.6KB | |
| VesaMount_r02.stl | 166.1KB |
