Vertical cell phone holder with opening for charger cable.
Version 03 modifications: reinforcement of the base where the phone is supported vertically!
Version Changes: https://www.thingiverse.com/thing:2194278
The piece: Phone_clamp_holder.stl, was made so that the phone is in the support vertically, also with the possibility of placing the cable to charge the cell phone while it is in the support. And with openings to use less material and print faster! The parts: Phone_clamp_up.stl, Phone_clamp_down.stl, were enlarged to hold the phone even with the cell phone cover. The rest of the pieces are from the original version, I put them here to facilitate the printing of the pieces.
Version 03: reinforcement of the base where the phone is supported vertically!
You can find instructions on how to assemble this link in the original version!
https://www.thingiverse.com/thing:2194278
I hope you like the changes! If you like it, click like! Have a good print!
| Flat_stand.stl | 275.6KB | |
| M5.0_Nut.stl | 73.0KB | |
| M5x65_D.stl | 3.5MB | |
| M5_knob_for_phone_v4.stl | 1.4MB | |
| M5_knob_long.stl | 3.9MB | |
| M5_knob_short.stl | 1.7MB | |
| Phone_clamp_down.stl | 435.5KB | |
| Phone_clamp_holder_v_03.stl | 516.4KB | |
| Phone_clamp_up.stl | 527.7KB |
