Vent Clip For Car 3D Printer Model
The file 'Vent Clip For Car 3D Printer Model' is (step,stl) file type, size is 282.8KB.
The file 'Vent Clip For Car 3D Printer Model' is (step,stl) file type, size is 282.8KB.
My clips broke on my phone mount for my car, so I made a new one in Fusion 360.
Mount was a Bracketron O2 Vent Mount, this slide right in like the original.
After printing put heat shrink over the ends to protect your vent from scratches.
Support is needed on the circle on the end as its 1mm off the build plate. I used support blockers in Cura so there was no supports on the smaller circular part.
Original step file is included so you can edit this for whatever use you may have.
| Clippy_Final.step | 471.0KB | |
| Clippy_Final.stl | 875.4KB |
