Vase optimized Moai-Planters with flat top
Can be used for cacti, flowers etc.
Lower overhang angles than the originals.
-->Can be printed without any support, infill or top layers!<---
Recommended print settings:
<=0.15mm Layer height are recommend
No infill, no top layers and no support necessary!
Object has a very critial zone on the back of the nose and the lip - If you want optimal printquality also on this part I would recommend to use 2 outline perimeters and not print in a vase mode, rather in a pseudo-vase mode were you are printing the inner of the two perimeters first as a secrent-support, because despite much lower overhang angles than the original its still not very easy without goof object cooling or very bridging-friendly filament to get a perfectly shaped nose back in vase mode - but you can still print it nicely using almost any printer when using 2 perimeters instead of one Vase-perimeter like I recommend
| Vase_Mode_optimized_Moai-Planter.stl |
| Vase_Mode_optimized_Moai-Planter_2.stl |
