The stand I formerly created was working fine, but added too much height and was not flexible in regards to angle the light is hitting the surface.
This is a simple gravity holding stand, the inside is pushed on the lamp, and the foot is holding it in position. There are 2 feet, a larger one and a small one.
2 of the insides can keep the lamp already at a more or less defines angle, adding one foot is sufficient to make it stable.
Print the inside and larger foot flat, the small foot can be printed upright.
Will develop as the 10mm wide version looks ... small though working.
Update 20191028: Added v3, a version to print both parts and the inside should not free itself. Just printing ... The idea is that something could be put over the lamps and not touching the warm surface, allowing some airflow.
| chihiros-inside-02-103.stl | 2.2MB | |
| chihiros-outside-01.stl | 3.1MB | |
| chihiros-outside-small-01.stl | 431.5KB | |
| chihiros_variable_stand_v3.stl | 6.7MB |
