WARNING: to not damage your controllers insure your print medium is slightly softer then the index plastic and sand any sharp/abrasive surfaces and edges before use. i am not responsible for any damage you cause by using this print.

estimated cost: 9-12 USD depending on print material.

for the Valve Index knuckles only.

parts required:
2-3 ft of 1/2" EMT conduit (metal pipe)
4 to 6 pairs of #10-24 x 5/8" nuts and bolts

please understand i am no professional and this is my first public print, however that being said please do still report any issues.

if this is what you where looking for please consider sending a buck or two my way to support future testing resin via https://ko-fi.com/ezurth

lastly please once again insure to sand the part after printing so it doesn't scratch your controllers.

how to attach and detach knuckles from stock

assembly tips:

• you can use the weld line on the pipe to keep your parts lined up.
• if you leave a longer pipe end it is recommended to use an old tennis ball on the tip to lessen any damage that may result from hitting something with the end.
• you can print mulltable grips to have at different points along the pipe to save you from needing to adjust their position when you switch to a different weapon.