Account depreciated please go here --> https://www.prusaprinters.org/social/173944-lolatron/prints
FOREWARNING. THIS DESIGN HASN'T BEEN TESTED LONG TERM AND MAY CAUSE DAMAGE TO THE CABLE OR HEADSET PLEASE DON'T CRY TO ME ABOUT IT BECAUSE I WILL MOST LIKELY BE CRYING ABOUT IT TOO.
Edit its been a few months and currently i haven't seen any major damage on the cable. I have broken it a few times but its better than the cable breaking. So i would recommend as much infill as possible and maybe making it out of petg or something that has a high ductile strength and can been a little bit without wanting to crack especially along the layer lines.
Cable saver for index. I made this after my cable started going bad. So I made this. Side effect is that it squished the current cable enough to use until the new cable gets here. This should in theory reduce the radius of the cables bends coming from the back of the headset. This should make sure the copper doesn't bend as much on the inside extending the life of the cable. Hopefully. It might just cause thighs to get worse idk. I'll make an update if the new cable goes bad.
| Cable_Saver_For_Index.f3d | 3.5MB | |
| Clip.stl | 1.7MB | |
| Spring.stl | 1.1MB |
![Cable Chain [2020 Aluminium Profile Compatible] 3D Printer Model](https://res.3axis.co/9bc52dde-d937-4d64-b334-e0029b870cad/images/806b1643-b892-491e-90a8-f28d25a07317_thumb.jpg)
